Stronger Echo sounder transducer position regulator PRO (Salt water AISI 316)

Description

This device is intended for getting / up of lowering and regulation of correct angle of slope of transducer sonic depth finder. It is necessary for the exact reflection of data echo of location in the cases of different trim of boat on a stern or on her nose. For the correct reflection of data of transducer must be strictly in parallel to the water smooth surface (to horizon). Thus, almost all manufacturers of echolocation equipment recommend installing their transducers. The reflected in this case signal got to them will most correctly represent information on the screen of your device!

In the basic kit for connecting the regulator to the control panel or remote button, a 2 meter cable is used. (tiller version) If your connection length exceeds 2 meters, then you will need to purchase an extension cable separately. Its length is 4 meters. And in this case, your total installation length is 6 meters. This length is sufficient for installation on the control console of almost any boat up to 7 meters long if the console is installed no further than the middle of the boat.

On a picture the variants of angles of slope of transducer, and also variants of fish, are higher presented on the screen of sonic depth finder. Overhead two pictures show wrong position of transducer, such position of sensor is possible either during the wrong primordial setting or in case of presence of longitudinal trim on a stern or on the nose of boat (more often – on a stern). Only in the case when a sensor is located strictly in parallel to horizon, information on the screen of your sonic depth finder is represented clearly and without distortions (lower picture). But an analogical situation takes place and with the picture of bottom of reservoir. At wrong position of sensor of transducer the real picture is so much distorted on the screen of your device. Therefore it is very important to obtain the correct angle of slope of transducer!

Boat depending on the amount of passengers, load placed on it, and also his weight and place of placing, yields to the longitudinal axial heel that in turn, can be directed both in nasal part and in feed part of boat. In investigation what the regularly set sensor in different situations not always represents information correctly.

Our device is sent exactly to that, to have the opportunity of remote electronic regulation of angle of slope of transducer.

During the protracted speed transitions, and also during the stand of boat, or in case, options of boat on a gun-carriage, you can heave up transducer on a maxheight practically in parallel to the stern of boat and to clean unnecessary resistance of sensor of sonic depth finder the same at water, to prevent becoming overgrown with transducer water-plants during a stand, and also to prevent breakage of sensor at a collision with water barriers or bottom of reservoir at going of boat a stern near a bank and on shoal.

Also getting up of sensor of transduser is very important in the moment of loading and further transporting of boat on a gun-carriage. For this purpose you press the key with a pointer upwards on the bearing-out button, or on control panels and sensor automatically will go up to eventual position.

We hope that by means of this device fishermen and active rest lovers on water will be able to improve quality, and also safety fishing on water, due to clear information that they will be able to get from the screen of the sonic depth finder! Well and certainly substantially to economize the budget on the purchase of new transduser!

Specification

Axleloading	200 n
Current on-loading	250 ma
Current no-load	75mA
Tension	12 v
Climbing ability is lowering	3.5 mm/s
Primary coolant	air
Method of cooling-line	water is air
Libra of transducer	to 1000 gramme
Time of continuous work	2 mines
Overall sizes of regulator	360 x 80 x 65 mm
Overall sizes are in packing	420 x 250 x 65 mm
Libra	1 kg
Guarantee	1 year
Model number	RL 200